Cleaning professionals think of floor care as both a science and an art. But in some cases, top-notch floor-cleaning equipment, superior chemicals, and even the best training cannot solve some of the common frustrations. The following are some of the frequent challenges faced with floor care, as well as their causes. You will find tactics that cleaning professionals like Spotless Commercial Cleaning in Durham, NC uses to manage them.
Poor Gloss
Before applying the finish, the floor should be properly stripped and rinsed. But if there is still no shine, then it is likely that you have applied very few coats of finish, or that the films are too thin. To avoid such problems, you should use the right scrubbing or buffing brushes/pads to avoid leaving excess grit and sand on the floor, and then rinse it properly before recoating in moderately thicker films.
Streaks in Floor Finish
Streaks are an indication that the recoating was applied too soon before the prior film had dried properly. They could also be a result of using a dirty mop or equipment, poor storage of the floor finish in extremely cold or hot conditions, contaminated finish, or application of floor finish over manufacturer finish on new tiles. To avoid streaks, always use clean equipment, strip and rinse well before applying, and give each coat 15 minutes to dry before re-applying. Any leftover finish should be disposed of.
Discolored Floor Finish
There are multiple things that can cause your floor finish to become discolored, including improper cleaner concentration; application of finish with new cotton mops before cleaning them; dirt, grit, and sand ground into the finish; leaving pH stripper residue on surface, and poor daily cleaning. To address these concerns, you should use an auto-scrubber with proper pads and cleaner daily, soak new rayon maps thoroughly before applying finish, follow the indicated cleaner dilution ration, deep scrub the surface before applying the coating, and rinse thoroughly after stripping to ensure that the pH is 7 or neutral.
It is important to remember that most problems are caused by excessive grit and dirt on the floor, use of dirty cleaning equipment, improper buffing or scrubbing, and failure to follow the application instructions. So, use recommended cleaning and cleaner application procedures or save in the long run by using a floor care service.
